instal the last version for ipod Lantern

INSTAL THE LAST VERSION FOR IPOD LANTERN DRIVER
INSTAL THE LAST VERSION FOR IPOD LANTERN CODE

Now, there are 2 ways to wire up the footwell lights in the Indian spec'd Polo from whatever homework I’ve done so far:ġ. Some cars come with the footwell lights pre-installed whereas some do not. 7700 Sir”!Ī footwell light aids in the ambient lighting in the car’s footwell regions. Out of curiosity, I asked the local VW Service Center for the price of the headlight switch and the representative replied, “ Rs. PS: The Vento has a brushed Aluminium trim on the knob instead of the chrome. The same switch can be seen on the Skoda Rapid as well: The shot of the connectors on the back of the switches: We are done! Looks much better than the stock one doesn’t it? Plug the connector to the new headlight switch, replace the switch into the socket and it should lock with the enclosure. The Octavia, Jetta, Passat and the Superb which have the 'Auto' headlamps have a different smaller connector.ĥ. Disconnect the harness from the rear of the unit by pulling the connector: Now hold the knob and pull the whole unit off the enclosure:Ĥ. Now, push the knob inward at position ‘O’ and turn it towards the next position i.e. I am sure quite a few of you may know this already but for those who don’t here goes a quick rundown.ġ. It is pretty easy to take out the headlight switch on the VAG cars and the procedure applies for almost all the cars right from the Polo, Rapid to the Passat and Superb. Here are the shots of the unit and the packaging it arrived in: Adds a bit of bling to the interiors with the chrome garnished knob. This is another simple, inexpensive DIY and doesn't require any tools. Replacing the bulbs with some CANBUS error-free LEDs would brighten up the cabin as well!Ĭourier: DPEX (proper tracking is available) We’re done! Test the results by switching on/off each map-reading light and opening/closing the door. Pry open the diffuser lens, secure the cabin light in place and screw the unit firmly: Plug the connector to the new cabin light:ħ. For the rest, secure it using the PU piece.Ħ. The OEM BT mic harness should be a perfect fit for this slot. Optional: If there is a mic harness from the HU, place it in the slot of the new cabin light: Disconnect the harness from the unit by pulling the connector off:ĥ. Release the tabs on either side of the light:Ĥ. Using the Torx head screw driver, unscrew the unit from the ceiling.

Using the card, pry open the diffuser lens from the stock cabin light:Ģ. An expired loyalty card or something similar.ġ. The black one used to be installed in the Laura vRS.Ģ. Additionally, there is a light beige ( 8YS) and black ( B41) variant as well.

INSTAL THE LAST VERSION FOR IPOD LANTERN CODE

This is a pearl grey colored unit (thus the color code Y20 at the end of the part number) which is suitable for the Polo’s grey headliner. Here are few shots of the unit and the packaging it arrived in: The RCD-510/RNS-510 can use a wireless BT mic harness whereas some others have a wired one like the one bundled with the Blaupunkt Philadelphia 835.Īnyways, here’s the image indicating various interior lights and their corresponding part numbers installed in the Polo sold abroad: Plus, a slot for securing the HU microphone.

INSTAL THE LAST VERSION FOR IPOD LANTERN DRIVER

The good thing about this unit is, in addition to the central light we get 2 additional reading/spot lights for the driver and the co-driver. This is a straight swap with the stock cabin light installed in the Polo here. Whereas this is the one inside the Polo sold abroad and the Vento sold here:Īnd this is the one installed in some of the variants of the Jetta, Golf, Laura and Fabia: This is the front cabin light inside the VW Polo sold here (i.e. For the benefit of the community, I thought of penning down this guide quickly. Not absolutely essential unlike an arm-rest or a dead pedal which is a must have but this lends an upmarket feel to the interiors of the cabin.įew BHP’ians have already swapped the cabin lights on their rides. This is a pretty simple DIY and a relatively inexpensive one for about 2000 INR.

Instal the last version for ipod Lantern